Lenovo THINK CENTRE 9159 Bedienungsanleitung Seite 30

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 48
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 29
9. Align the drive bay assembly with the two slots and rails on the sides of the
chassis, reconnect the drive cables on the system board, and then slide the
drive bay assembly towards the rear of the chassis until it snaps into position.
10. Reinstall the front bezel.
11. Go to Capitolo 4, “Completing the parts replacement”, a pagina 31.
Replacing the diskette drive
Attention
Do not open your computer or attempt any repair before reading the “Important safety
information” in the Safety and Warranty Guide that was included with your computer for
the computer. To obtain copies of the Safety and Warranty Guide, go to
http://www.lenovo.com/support.
This section provides instructions on how to replace the diskette drive.
1. Remove the computer cover. See “Removing the cover” a pagina 9.
2. Remove the bezel and drive bay assembly. See “Accessing system board
components and drives” a pagina 10.
3. Release the diskette drive by pressing inward on the blue retainer at the side of
the drive.
4. Remove the failing diskette drive by sliding it out the front of the drive bay
assembly.
5. Remove the retainer bracket from the failing drive and install it on the new
drive.
6. Install the new diskette drive into the drive bay from the front until it snaps
into position.
Figura 24. Removing the diskette drive
Figura 25. Retaining bracket for diskette drive
22 Hardware Installation and Replacement Guide
Seitenansicht 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare