Lenovo THINK CENTRE 9159 Bedienungsanleitung PDF herunterladen (Seite 26)

2. Locate the available SATA connector on the system board. See “Identifying

parts on the system board” a pagina 7.

3. Connect one end of the signal cable to the drive and the other to the available

SATA connector on the system board.

4. Locate one of the extra five-wire power connectors and connect it to the drive.

What to do next:

v To work with another option, go to the appropriate section.

v To complete the installation, go to Capitolo 4, “Completing the parts

replacement”, a pagina 31.

Installing a diskette drive in bay 3

To install a diskette drive in bay 3, do the following:

1. Remove the computer cover. See “Removing the cover” a pagina 9.

2. Access the system board. See “Accessing system board components and drives”

a pagina 10.

3. Remove the metal shield from the diskette drive bay by using a flat-blade

screwdriver to gently pry it loose.

4. Remove the plastic panel in the bezel by squeezing the plastic tabs that secure

the panel on the inside of the bezel.

5. Install a retainer bracket on the side of the diskette drive.

6. Install the diskette drive into the bay from the front until it snaps into position.

Figura 17. Connecting a serial ATA drive

Figura 18. Retaining bracket

Figura 19. Installing the diskette drive

18 Hardware Installation and Replacement Guide

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 47 48

Keine Kommentare

Lenovo THINK CENTRE 9159 Bedienungsanleitung Seite 26