Lenovo THINK CENTRE 9159 Bedienungsanleitung PDF herunterladen (Seite 25)

Nota: When installing the Universal Adapter Bracket, if the retaining bracket is

not available, install the screws to secure the adapter bracket into the drive bay.

6. Install the drive into the drive bay until it snaps into position.

7. Align the drive bay assembly with the two slots and rails on the sides of the

chassis and connect the new drive cable on the system board. See “Connecting

drives”.

Connecting drives

The steps to connect a drive are different depending on the type of drive that you

are connecting. Use one of the following procedures for your drive connection.

Connecting an optical drive or a parallel ATA hard disk drive:

1. Locate the two-connector signal cable that comes with your computer or with

the new drive.

2. Locate the IDE connector 1 on the system board. See “Identifying parts on the

system board” a pagina 7.

3. Connect one end of the signal cable to the drive and the other to the IDE

connector 1 on the system board.

4. Locate the extra four-wire power connector labelled P4 and connect it to the

drive.

Connecting an additional serial ATA hard disk drive: A serial hard disk drive

can be connected to any available SATA connector.

1. Locate the signal cable that comes with the new drive.

Figura 14. Retaining bracket

Figura 15. Installing the drive

Figura 16. Connecting a parallel ATA hard disk drive

Capitolo 3. Installing options and replacing hardware 17

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

Keine Kommentare

Lenovo THINK CENTRE 9159 Bedienungsanleitung Seite 25