Lenovo E200 Bedienungsanleitung PDF herunterladen (Seite 72)

Diagnostic Error Code FRU/Action

025-198-XXX

IDE interface test aborted

1. If a component is called out, make sure

it is connected and/or enabled. See

Chapter 6, “Using the Setup Utility,” on

page 49

2. Flash the system and re-test. See “Flash

update procedures” on page 111

3. Go to “Undetermined problems” on page

78

025-199-XXX

IDE interface test failed, cause unknown

1. Go to “Undetermined problems” on page

78

2. Flash the system and re-test. See “Flash

update procedures” on page 111

3. Replace component under function test

030-000-XXX

SCSI interface Test Passed

No action

030-00X-XXX

030-01X-XXX

SCSI interface failure

1. SCSI signal cable

2. Check power supply

3. SCSI device

4. SCSI adapter card, if installed

5. System board

030-027-XXX

SCSI interface Configuration/Setup error

1. SCSI signal cable

2. Flash the system. See “Flash update

procedures” on page 111

3. SCSI device

4. SCSI adapter card, if installed

5. System board

030-03X-XXX

030-04X-XXX

SCSI interface error

1. SCSI signal cable

2. Check power supply

3. SCSI device

4. SCSI adapter card, if installed

5. System board

030-195-XXX

SCSI interface Test aborted by user

Information only

Re-start the test, if necessary

030-196-XXX

SCSI interface test halt, error threshold

exceeded

1. Press F3 to review the log file

2. Re-start the test to reset the log file

030-197-XXX

SCSI interface test warning

1. Make sure the component that is called

out is connected and/or enabled. See

Chapter 6, “Using the Setup Utility,” on

page 49

2. Re-run test

3. Replace the component that is called out

in warning statement

4. Replace the component under test

66 Lenovo E200 Hardware Maintenance Manual

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 123 124

Kommentare zu diesen Handbüchern

Keine Kommentare