Lenovo E200 Bedienungsanleitung PDF herunterladen (Seite 110)

Replacing a hard disk drive

Attention

Do not open your computer or attempt any repair before reading and understanding the

“Important safety information” in the ThinkCentre Safety and Warranty Guide that came with

your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:

http://www.lenovo.com/support

Important

When you install a new hard disk drive, you also need a set of Product

Recovery discs. The set of Product Recovery discs will enable the contents of the

hard disk to be restored to the same state as when the computer was

originally shipped from the factory. For more information on recovering

factory-installed software, refer to “Recovering software” in the User Guide.

1. Remove the covers. See “Removing the computer cover” on page 86.

2. Disconnect the signal and power cables from the rear of the hard disk drive.

3. Remove the four screws that secure the hard disk drive from the drive bay.

4. Slide the drive toward the rear of the chassis until it can be removed.

5. Slide the new drive into the bay until the screws holes are aligned and install

the four screws into the drive bay.

6. Reconnect the signal and power cables to the rear of the hard disk drive.

7. Go to “Completing the FRU replacement” on page 107.

104 Lenovo E200 Hardware Maintenance Manual

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 123 124

Keine Kommentare

Lenovo E200 Bedienungsanleitung Seite 110