Lenovo USB 2.0 CD-RW/DVD-ROM Combo II Drive Bedienungsanleitung PDF herunterladen (Seite 27)

Chapter 5. Combo II Drive hardware installation and removal

in Windows 2000 and Windows XP

Windows 2000 and Windows XP operating systems have the native drivers for the

Combo II Drive. Therefore, when this drive is connected, Windows will

automatically install the appropriate driver and the drive will be ready to be used.

You do not have to perform any special installation or removal procedures.

Attention:

v This drive will be recognized as ″CD-RW/DVD-ROM″ by Windows Device Manager.

v In Windows 2000 operating systems, Service Pack 4 or later must be installed.

Removing the Combo II Drive hardware

″Hot plug″ is supported for the connection between the USB cable and the

computer; therefore you don’t need to turn off the computer when you remove the

Combo II Drive. Follow the procedure below for removing the Combo II Drive for

Windows 2000 and Windows XP.

Attention:

Do not remove and reconnect the drive from or to the computer in rapid succession. The

drive may not be recognized. Reconnect the drive approximately 20 seconds after

removing.

Use the Tray icon for this procedure.

Windows 2000

1. Exit the program that uses the drive.

2. Confirm that the Write indicator of the drive is off.

3. Click the Unplug or Eject Hardware icon on the tray.

4. Select removing drive. In this case, select the drive name assigned to the drive

(D: in this figure).

5. The Safe to Remove Hardware confirmation window appears. Click the OK

button.

6. Remove the plug of the USB cable from the USB terminal of the computer.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 73 74

Keine Kommentare

Lenovo USB 2.0 CD-RW/DVD-ROM Combo II Drive Bedienungsanleitung Seite 27