Lenovo THINKCENTRE 6019 Bedienungsanleitung PDF herunterladen (Seite 57)

100

101

Note: Selecting a startup device from the Startup Device menu does not

permanently change the startup sequence.

Selecting or changing the startup device sequence

To view or permanently change the configured startup device sequence, do the

following:

1. Start the Setup Utility program (see “Starting the Setup Utility program” on

page 49).

2. Select Startup.

3. Select Startup Sequence. See the information displayed on the right side of the

screen.

4. Select the devices for the Primary Startup Sequence, the Automatic Startup

Sequence, and the Error Startup Sequence.

5. Select Exit from the Setup Utility menu and then Save Settings or Save and

exit the Setup Utility.

If you have changed these settings and want to return to the default settings, select

Load Default Settings on the Exit menu.

Advanced settings

On some computer models the Advanced settings menu includes a setting to

Enable/Disable HyperThreading. This feature works only with

HyperThreading-aware operating systems, such as Microsoft Windows XP and

Windows Vista

™

. The default setting for HyperThreading is Enabled. However, if

you select Set Defaults and are using an operating system other than Windows XP

or Windows Vista, the computer performance might be degraded. Therefore, you

should always set HyperThreading to Disabled unless you are sure your operating

system supports HyperThreading.

Exiting from the Setup Utility program

When you finish viewing or changing settings, press Esc to return to the Setup

Utility program menu (you might have to press Esc several times). If you want to

save the new settings, select Save & Exit Setup before you exit. Otherwise, your

changes will not be saved.

Chapter 6. Using the Setup Utility 51

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 505 506

Kommentare zu diesen Handbüchern

Keine Kommentare

Lenovo THINKCENTRE 6019 Bedienungsanleitung Seite 57

Kommentare zu diesen Handbüchern